| |
|
| Applications Instructions |
| |
| 1. |
The surface of the wheelie bin where your new numbers are to be places, must be totally free from all dirt, grease, moisture, grime, bugs other stickers /old sticker residue etc... |
| |
|
| 2. |
Without removing the backing paper, position your new numbers on bin exactly where you want it ensuring it is level. |
| |
|
| 3. |
Once the WheelieBinNumber sticker is in position, place a piece of masking tape along the top edge to hold the WheelieBinNumber sticker in place. |
| |
|
| 4. |
The WheelieBinNumber sticker should be sitting on your bin like a flap. Lift up the sticker (A) and remove the paper backing (B). |
| |
|
| 5. |
With the backing paper completely removed from the sticker & transfer tape, gently lower the WheelieBinNumber sticker with the transfer tape back down to the surface of the bin and rub it down lightly with your hand |
| |
|
| 6. |
Taking a squeegee or similar applicator, firmly rub the vinyl sticker down to the bin ensuring not to scrape or tear the vinyl numbers which are still covered with transfer tape. |
| |
|
| 7. |
Finally, peel off the transfer tape and masking tape gently and slowly. The WheelieBinNumber sticker will adhere to the surface much more effectively than the transfer tape. The transfer tape should lift easily leaving behind no sticky residue. |
| |
|
| 8. |
CONGRATULATIONS!
Your WheelieBinNumber sticker installation is complete.
If there are bubbles present under the sticker that cannot be removed by working them to the edge, a small needle or pin can be used to puncture the bubble and remove the air. A small pin hole will not be seen after the air bubble has been worked out. |
| |
|
|
|
Contact Us Today: 61B Baldoyle Industrial Estate, Baldoyle, Dublin 13, Ireland | Tel: +353 (01) 440 6666 | Fax: +353 (01) 839 7290
